(Your shopping cart is empty)
LIGHTING: LED AQUARIUM LIGHTING
LIGHTING: LED REEF & PLANTED TANK LIGHTING
(T5 & T12)
Accept Credit Cards
Join our mailing list
Join our mailing list!
Additives by Manufacturer:
Brightwell Aquatics PhosphatR Regenerable Phosphate Resin, 500 ml
Stock Status:In Stock
Next-generation regenerable phosphate adsorption resin
effective in marine aquaria; will also remove silicates
Far more effective than activated alumina and granular ferric
Will not negatively impact water quality nor release phosphate
or silicate once exhausted; will not break up or disintegrate like ferric medias, and contains no aluminum to dissolve in aquaria and harm inhabitants
Synthetic polymer resin beads provide for durability and excellent flow characteristics; may be employed in fluidized-bed, canister, or passive filtration
Regenerable up to five times using
Brightwell Aquatics RegeneratPHOR Resin Regenerator
, dramatically increasing cost effectiveness
Basic Instructions: Prior to first use, rinse resin under a stream of purified water. For initial application on aquarium, use 1 ml of PhosphatR per 1 US-gallon of water in system and monitor phosphate concentration during usage. Subsequent application of resin may be at the rate of 2 ml per 1 US-gallon.
Prior to first use, rinse resin under a stream of purified water. For initial application on aquarium, use 1 ml of PhosphatR per 1 US-gallon of water in system and monitor phosphate concentration during usage. Subsequent application of resin may be at the rate of 2 ml per 1 US-gallon.
Prior to first use, rinse resin under a stream of purified water. To a point, effectiveness of resin is directly related to the reaction time it has with aquarium water; the longer the reaction time, the more effectively it will remove phosphate and silicate. Once phosphate concentration (”[PO43-]”) has not changed for a period of 4 - 6 hours, remove and regenerate resin, then reapply if necessary. In all cases, the use of a mechanical pre-filter to remove particulate organic material from water prior to its interaction with this media will prolong effectiveness. Fluidized-bed filtration (recommended): follow instructions of filter manufacturer for optimal volume of media to use in reaction chamber; start at a low flow rate and adjust to keep media in a steady “boil” within lower 2/3 of chamber; flow rate should not be such that resin is ejected into aquarium. Canister filtration: Load resin into filter cartridge as directed by filter manufacturer; leave resin in place until [PO43-] reaches desired level or remains unchanged, as directed above. Slowing the flow of water through the filter may be required to obtain maximum effectiveness of resin. Passive filtration: Place resin loosely in a 150µm mesh filter bag and locate in an area of low- to medium-flow. Turning bag over once during usage will serve to shift the resin beads and increases effectivness of this method. Regenerate PhosphatR with Brightwell Aquatics RegeneratPHOR
Resin sold moist. Keep closed to prevent drying. Weight varies due to moisture content, therefore product is sold by volume rather than weight.
Keep out of reach of children. Not for human consumption.
Browse for more products in the same category as this item:
Additives by Manufacturer:
Aquarium Chemical Filtration Media:
About Us/Contact Info
Manufacturer Contact Info
Copyright © 2007 www.marineandreef.com. All Rights Reserved.